Sensor membrane with wear-resistant protective film
In many filling processes, spray on the sensor membrane simply cannot be avoided. These sprays often harden so that after longer periods of operation contamination can only be removed from the sensor membrane by mechanical means. The new protective film of the crm+ sensors now makes it easy to remove caked-on soiling, such as hardened casting compound and cement spatter.

하이라이트

Ultrasonic transducer protected by PEEK film for simple cleaning and high resistance to wear
Stainless-steel housing
Digital display with direct measured value output in mm/cm or %
Numeric configuration of the sensor using digital display permits the complete advance configuration of the sensor
Automatic synchronisation and multiplex operation for simultaneous operation of up to ten sensors in close quarters

BASICS

1 or 2 switching outputs in pnp variant
Analogue output 4–20 mA and 0–10 V with automatic switching between current and voltage outputs
5 detection ranges with a measurement range of 30 mm to 8 m
microsonic Teach-in using T1 or T2 buttons
0.025 mm to 2.4 mm resolution
Temperature compensation
9–30 V operating voltage
LinkControl for configuration of sensors from a PC